Unit Structure for Using Gas Injection Technology
To use Gas Injection Technology you need the following equipment:
Injectors to permit the gas penetration in the fused plastic materials.
A high-precision dosing unit managing the gas pressure level according to time.
A high pressure compressor unit permitting Nitrogen compression and storage under high pressure.
A nitrogen source by bottle, bulk (fluid) or produced by a generator.
A Flushing Modul (pressurised gas flushing system) enables heat to be transferred out of the component rapidly, reducing the cycle time needed to cool and increasing performance and productivity.
A mass flow meter to measure the quantity of gas injected into the mould - per valve.
A BY-PASS Valve to avoid pollution from polymer additives.